avatar  


Recently viewed tickets

Log out

Camera control

Introduction

The Confidea conference system supports camera control. The WCAP sends out data via UDP to the camera system. The camera control function can be enabled using the Confidea web server. How you can do this, is described below.

Configure camera control

To combine the Confidea WCAP with the camera control feature, follow the steps described below:

  1. Go to Network settings in the main menu.
  2. In the Camera protocol panel enable the setting by selecting the Enabled checkbox.
  3. Fill in the IP address of the camera system.
  4. Define the destination port. The default UDP communication port is 8000. When you select a port manually using the web server, the port number should be larger than 3000.

    Figure 1-24 Camera control settings in the Plixus web server

The WCAP sends data to the camera after a microphone button event in JSON format: {“UID�?: micnr,“status�?: x}.

- Micnr : is the microphone number , can be one or more digits.

- Status : 0 = off, 1 = on, 2 = request , 3 = prior

For example: data sent when microphone 7 is in request : {“UID�?: 7,“status�?: 2}

Creation date: 10/09/2019 11:32 (b.maertens@televic.com)      Updated: 16/10/2019 14:12 (j.callant@televic.com)